02-03-2015, 01:21 PM
(02-03-2015, 11:41 AM)fix Wrote: I haven't decided on the ejector yet. I'm thinking about adding a bit of metal under the barrel and cutting in a flat is extractor.
Since you reminded me though, I did put the stud in and make the finger nut that holds the barrel on. It's very similar to the original design, just reversed. Rather than the bolt coming out, mine just has a finger nut that comes off.
I got to use the indexing feature on my lathe for the first time cutting the teeth for the finger nut.
Brass would look good for the side plates, if a guy had and old kick plate off a school house door laying around.
DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!