MetalworkingFun Forum › Machining › General Metalworking Discussion v
input needed

Thread Modes
input needed
BertieBassett Offline
Freshman
**
Posts: 1
Threads: 0
Joined: Oct 2014
Location: UK
The following 1 user Likes BertieBassett's post:
EdK (02-01-2015)
#11
02-01-2015, 03:52 PM
wouldn't it be much simpler just to screw the ends on, and lock with a set screw?

female thread in the main shaft and a male thread on the end piece with a run out groove for a locking set screw to make sure it cant come apart
Reply
Thanks given by:


Messages In This Thread
input needed - by swordplayer - 02-01-2015, 06:34 AM
RE: input needed - by Black Forest - 02-01-2015, 07:21 AM
RE: input needed - by swordplayer - 02-01-2015, 09:06 AM
RE: input needed - by swordplayer - 02-01-2015, 09:18 AM
RE: input needed - by PixMan - 02-01-2015, 09:24 AM
RE: input needed - by swordplayer - 02-01-2015, 09:35 AM
RE: input needed - by Hawkeye - 02-01-2015, 11:48 AM
RE: input needed - by rleete - 02-01-2015, 12:16 PM
RE: input needed - by Black Forest - 02-01-2015, 01:31 PM
RE: input needed - by Highpower - 02-01-2015, 01:33 PM
RE: input needed - by BertieBassett - 02-01-2015, 03:52 PM
RE: input needed - by swordplayer - 02-01-2015, 04:31 PM
RE: input needed - by swordplayer - 02-01-2015, 04:38 PM



Users browsing this thread: 1 Guest(s)