Let's see your bandsaw

[glens5]

                   

This is my homemade 6" x 10" that I put together a year or so ago.
9 1/2" wheels trued up on my SB9. Hydraulic down feed actuated with a solenoid, it's coil in parallel with the motor windings.
A calibrated blade pressure adjuster. Also a bypass for quick positioning of the blade and an auto shutoff.
6203-2rs bearings in the upper wheel and the main shaft for the arm. 6000-2rs bearings for the blade guides with eccentric offsets for blade width adjustment.
Three speeds. 80, 140 and 210 FPM.