MetalworkingFun Forum › Machining › General Metalworking Discussion v
input needed

Thread Modes
input needed
Hawkeye Offline
Junior
****
Posts: 535
Threads: 39
Joined: Jan 2013
Location: Kelowna, BC, Canada
#7
02-01-2015, 11:48 AM
Check out some store that carries speciallised fasteners. Ace Hardware comes to mind. I'm thinking of a two-part bolt that consists of an outer barrel with a flat, wide head that has in internal thread. The other part has the same head, with an external thread that runs inside the first part. They usually have slots in the heads for tightening and would be the least conspicuous.
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:


Messages In This Thread
input needed - by swordplayer - 02-01-2015, 06:34 AM
RE: input needed - by Black Forest - 02-01-2015, 07:21 AM
RE: input needed - by swordplayer - 02-01-2015, 09:06 AM
RE: input needed - by swordplayer - 02-01-2015, 09:18 AM
RE: input needed - by PixMan - 02-01-2015, 09:24 AM
RE: input needed - by swordplayer - 02-01-2015, 09:35 AM
RE: input needed - by Hawkeye - 02-01-2015, 11:48 AM
RE: input needed - by rleete - 02-01-2015, 12:16 PM
RE: input needed - by Black Forest - 02-01-2015, 01:31 PM
RE: input needed - by Highpower - 02-01-2015, 01:33 PM
RE: input needed - by BertieBassett - 02-01-2015, 03:52 PM
RE: input needed - by swordplayer - 02-01-2015, 04:31 PM
RE: input needed - by swordplayer - 02-01-2015, 04:38 PM



Users browsing this thread: 2 Guest(s)