02-01-2015, 09:49 AM
Sounds like a no-brainer to me: Bolt on the new one and use it with a 10mm drill to transfer location to the machine base, tap in the new 10mm roll pins and done.
BTW, you need a ball on the end of you quill feed engagement clutch. Don't use anything heavier than the plastic ball that was originally there, you don't want excess weight to change the dynamics of engage/release.
BTW, you need a ball on the end of you quill feed engagement clutch. Don't use anything heavier than the plastic ball that was originally there, you don't want excess weight to change the dynamics of engage/release.