02-01-2015, 08:37 AM
Unfortunately, it is not operational. I just needed to clean up my bench at the workshop where the head has been residing, as I will need it when I rebuild the engine in my Mum's car.
The table is still off and I have to unblock two oil galleys or the oilers themselves on the saddle first. I then have to make the decision as to whether I drill and ream the locating holes for the yoke to suit the one I bought or put those nuts into the original yoke.
There are other jobs that will need to be done, such as making locks and draw bars (I have tooling that requires M12x1.75, 1/2-12 and 1/2-13). Some of these will need to be done to get her running but others can be done afterwards.
I also need to know if there is a specific break-in procedure for the new spindle bearings I put in.
The table is still off and I have to unblock two oil galleys or the oilers themselves on the saddle first. I then have to make the decision as to whether I drill and ream the locating holes for the yoke to suit the one I bought or put those nuts into the original yoke.
There are other jobs that will need to be done, such as making locks and draw bars (I have tooling that requires M12x1.75, 1/2-12 and 1/2-13). Some of these will need to be done to get her running but others can be done afterwards.
I also need to know if there is a specific break-in procedure for the new spindle bearings I put in.
Hunting American dentists since 2015.