MetalworkingFun Forum › Machining › General Metalworking Discussion v
Mr. Woodwright goes metal!

Thread Modes
Mr. Woodwright goes metal!
f350ca Offline
Senior
*****
Posts: 3,003
Threads: 51
Joined: Apr 2012
Location: Ontario
#4
01-31-2015, 01:57 PM
Very neat, did you catch where he was running the centre bit into the end grain.
If you find one of those Tom you'll be getting rid of the Hardinge.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
Mr. Woodwright goes metal! - by TomG - 01-31-2015, 10:48 AM
RE: Mr. Woodwright goes metal! - by DaveH - 01-31-2015, 11:32 AM
RE: Mr. Woodwright goes metal! - by TomG - 01-31-2015, 11:35 AM
RE: Mr. Woodwright goes metal! - by f350ca - 01-31-2015, 01:57 PM
RE: Mr. Woodwright goes metal! - by EdK - 01-31-2015, 02:28 PM
RE: Mr. Woodwright goes metal! - by oldgoaly - 01-31-2015, 03:20 PM
RE: Mr. Woodwright goes metal! - by TomG - 01-31-2015, 03:52 PM
RE: Mr. Woodwright goes metal! - by oldgoaly - 02-01-2015, 12:32 AM
RE: Mr. Woodwright goes metal! - by TomG - 02-01-2015, 12:51 AM
RE: Mr. Woodwright goes metal! - by Micktoon - 02-01-2015, 06:38 PM



Users browsing this thread: 2 Guest(s)