01-29-2015, 01:59 PM
Make a disc to fit the inside cut out put a little hole in the centre of the disc and align that up 
DaveH
DaveH
|
Help Centering on a rotary table
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Centering on a rotary table - by Dan Boy - 01-29-2015, 01:55 PM
RE: Centering on a rotary table - by DaveH - 01-29-2015, 01:59 PM
RE: Centering on a rotary table - by Highpower - 01-29-2015, 04:30 PM
RE: Centering on a rotary table - by f350ca - 01-29-2015, 06:10 PM
RE: Centering on a rotary table - by PixMan - 01-29-2015, 08:48 PM
RE: Centering on a rotary table - by Dan Boy - 01-30-2015, 01:53 AM
RE: Centering on a rotary table - by Dan Boy - 01-30-2015, 01:54 AM
RE: Centering on a rotary table - by Shawn - 01-30-2015, 05:13 AM
RE: Centering on a rotary table - by RobWilson - 01-30-2015, 01:48 PM
RE: Centering on a rotary table - by TomG - 01-30-2015, 06:09 PM
RE: Centering on a rotary table - by Shawn - 01-31-2015, 02:58 AM
RE: Centering on a rotary table - by Maxiice - 01-31-2015, 11:01 AM
RE: Centering on a rotary table - by ScrapMetal - 02-02-2015, 10:50 PM
|
Users browsing this thread: 3 Guest(s)