MetalworkingFun Forum › Machining › General Metalworking Discussion v
Form tools on the lathe

Thread Modes
Form tools on the lathe
Shawn Offline
Junior
****
Posts: 313
Threads: 34
Joined: Nov 2013
Location: Kamloops, BC, Canada
#3
01-28-2015, 06:55 PM
Had a  go on some 12L14 and it cut no problem. If I had of been thinking I would have cut a profile in both ends of the form tools! Blush


[Image: image.jpg]
Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.
Reply
Thanks given by:


Messages In This Thread
Form tools on the lathe - by Shawn - 01-28-2015, 05:40 PM
RE: Form tools on the lathe - by Shawn - 01-28-2015, 05:46 PM
RE: Form tools on the lathe - by Shawn - 01-28-2015, 06:55 PM
RE: Form tools on the lathe - by DaveH - 01-28-2015, 07:10 PM
RE: Form tools on the lathe - by Shawn - 01-28-2015, 07:20 PM
RE: Form tools on the lathe - by dallen - 01-28-2015, 07:42 PM
RE: Form tools on the lathe - by DaveH - 01-28-2015, 07:50 PM
RE: Form tools on the lathe - by Highpower - 01-28-2015, 11:56 PM
RE: Form tools on the lathe - by Shawn - 01-28-2015, 07:55 PM
RE: Form tools on the lathe - by DaveH - 01-28-2015, 07:57 PM
RE: Form tools on the lathe - by Mayhem - 01-29-2015, 06:31 AM
RE: Form tools on the lathe - by dallen - 01-29-2015, 09:15 AM
RE: Form tools on the lathe - by vtsteam - 01-29-2015, 11:15 AM
RE: Form tools on the lathe - by Baron - 02-15-2015, 04:54 PM
RE: Form tools on the lathe - by Shawn - 02-16-2015, 11:10 PM



Users browsing this thread: 2 Guest(s)