Form tools on the lathe
#2
Here's a better shot of the first tool, I was spinning the lathe in its lowest gear (direct drive) and didn't get any chatter but the work did want to ride up on the tool if I plunged to aggressively. I will try it in back gear and see if that helps any. 

[Image: image.jpg]
Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.
Reply
Thanks given by:


Messages In This Thread
Form tools on the lathe - by Shawn - 01-28-2015, 05:40 PM
RE: Form tools on the lathe - by Shawn - 01-28-2015, 05:46 PM
RE: Form tools on the lathe - by Shawn - 01-28-2015, 06:55 PM
RE: Form tools on the lathe - by DaveH - 01-28-2015, 07:10 PM
RE: Form tools on the lathe - by Shawn - 01-28-2015, 07:20 PM
RE: Form tools on the lathe - by dallen - 01-28-2015, 07:42 PM
RE: Form tools on the lathe - by DaveH - 01-28-2015, 07:50 PM
RE: Form tools on the lathe - by Highpower - 01-28-2015, 11:56 PM
RE: Form tools on the lathe - by Shawn - 01-28-2015, 07:55 PM
RE: Form tools on the lathe - by DaveH - 01-28-2015, 07:57 PM
RE: Form tools on the lathe - by Mayhem - 01-29-2015, 06:31 AM
RE: Form tools on the lathe - by dallen - 01-29-2015, 09:15 AM
RE: Form tools on the lathe - by vtsteam - 01-29-2015, 11:15 AM
RE: Form tools on the lathe - by Baron - 02-15-2015, 04:54 PM
RE: Form tools on the lathe - by Shawn - 02-16-2015, 11:10 PM



Users browsing this thread: 3 Guest(s)