Good results in cold rolled mild steel bar
#8
I was thinking it was probably how sharp the edge was with the added angle of the chip breaker that made the difference. What I did learn for sure was I need to keep tweaking my tool grinding skills and experimenting with different geometry. I might be sick but I actually enjoy grinding HSS bits, requires some concentration and provides me with instant gratification. I have a lifetime supply of high quality HSS/cobalt blanks so I will be grinding for years yet, will definately give inserts a go at some point though.
Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.
Reply
Thanks given by:


Messages In This Thread
RE: Good results in cold rolled mild steel bar - by Shawn - 01-27-2015, 04:53 PM



Users browsing this thread: 2 Guest(s)