DRO On Lathe
#12
Wow! What a difference it makes when it's set up correctly. I did some trial cuts on the bore and measured with the inside micrometer and the DRO matched the micrometer dead on. This is going to save so much time being able to trust the DRO now.  Smiley-dancenana

Ed
Reply
Thanks given by:


Messages In This Thread
DRO On Lathe - by EdK - 01-27-2015, 11:03 AM
RE: DRO On Lathe - by PixMan - 01-27-2015, 11:40 AM
RE: DRO On Lathe - by f350ca - 01-27-2015, 12:17 PM
RE: DRO On Lathe - by EdK - 01-27-2015, 12:26 PM
RE: DRO On Lathe - by PixMan - 01-27-2015, 12:40 PM
RE: DRO On Lathe - by EdK - 01-27-2015, 12:56 PM
RE: DRO On Lathe - by EdK - 01-27-2015, 12:49 PM
RE: DRO On Lathe - by f350ca - 01-27-2015, 02:20 PM
RE: DRO On Lathe - by EdK - 01-27-2015, 02:32 PM
RE: DRO On Lathe - by stevec - 01-27-2015, 02:42 PM
RE: DRO On Lathe - by EdK - 01-27-2015, 03:02 PM
RE: DRO On Lathe - by EdK - 01-27-2015, 04:31 PM
RE: DRO On Lathe - by PixMan - 01-27-2015, 05:02 PM
RE: DRO On Lathe - by DriftStar - 01-27-2015, 05:10 PM
RE: DRO On Lathe - by EdK - 01-27-2015, 06:00 PM
RE: DRO On Lathe - by f350ca - 01-27-2015, 06:09 PM
RE: DRO On Lathe - by EdK - 01-27-2015, 06:23 PM



Users browsing this thread: 2 Guest(s)