01-27-2015, 02:32 PM
(01-27-2015, 02:20 PM)f350ca Wrote: Ed, if the count goes up as you move the cross slide to the back, (ie as the dia gets smaller, then the scale needs to be reversed, electronically in the readout. The manual should tell you how. If thus is the case it must not work for OD turning either, OD ID is the same. A quick fix is enter your measured dia as a negative number.
Greg,
I can change the direction of the count to fix the cross slide. What I'm still wondering is what should the count do for the carriage when moved towards the head stock? I'm assuming it should decrease but I'm not sure.
Ed