The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › General Metalworking Discussion v
Good results in cold rolled mild steel bar

Thread Modes
Good results in cold rolled mild steel bar
Shawn Offline
Junior
****
Posts: 313
Threads: 34
Joined: Nov 2013
Location: Kamloops, BC, Canada
The following 1 user Likes Shawn's post:
f350ca (01-27-2015)
#1
01-27-2015, 12:32 AM (This post was last modified: 01-27-2015, 12:33 AM by Shawn.)
I have always had less than great results turning cold rolled steel bar and have used a shear tool when I wanted a nice finish. I was watching a few videos showing a couple YouTube regulars having a bit of a tool grinding, removal rate competition and thought I would have a go grinding a chip breaker into a tool. I had to double check that it wasn't 12L14 I was turning by mistake!! The results probably aren't all due to the chip breaker but it did show me I have a lot left to learn about grinding lathe/shaper tools  Big Grin

[Image: image.jpg]
Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.
Reply
Thanks given by:


Messages In This Thread
Good results in cold rolled mild steel bar - by Shawn - 01-27-2015, 12:32 AM



Users browsing this thread: 3 Guest(s)