MetalworkingFun Forum › Machining › General Metalworking Discussion v
Edge Finder Disassembly

Thread Modes
Edge Finder Disassembly
mcostello Offline
Freshman
**
Posts: 26
Threads: 6
Joined: Jul 2014
Location: Lancaster, Ohio
The following 4 users Like mcostello's post:
EdK (01-19-2015), Mayhem (01-19-2015), Highpower (01-19-2015), PixMan (01-19-2015)
#21
01-19-2015, 12:44 PM
If easy dis-assembly is Your goal, just "bump" a part too hard when "finding" it in Your mill vise. Finding the spring and reassembling it is another matter.
mcostello, proud to be a member of MetalworkingFun Forum since Jul 2014.
Reply
Thanks given by:


Messages In This Thread
Edge Finder Disassembly - by EdK - 10-19-2014, 08:43 AM
RE: Edge Finder Disassembly - by Mayhem - 10-19-2014, 09:01 AM
RE: Edge Finder Disassembly - by EdK - 10-19-2014, 09:09 AM
RE: Edge Finder Disassembly - by dallen - 10-19-2014, 10:23 AM
RE: Edge Finder Disassembly - by Highpower - 10-19-2014, 10:31 AM
RE: Edge Finder Disassembly - by EdK - 10-19-2014, 12:14 PM
RE: Edge Finder Disassembly - by f350ca - 10-19-2014, 12:39 PM
RE: Edge Finder Disassembly - by EdK - 10-19-2014, 03:31 PM
RE: Edge Finder Disassembly - by stevec - 01-18-2015, 08:23 AM
RE: Edge Finder Disassembly - by arvidj - 01-18-2015, 09:19 AM
RE: Edge Finder Disassembly - by Tony Wells - 01-18-2015, 02:48 AM
RE: Edge Finder Disassembly - by Arbalest - 01-18-2015, 06:34 AM
RE: Edge Finder Disassembly - by DaveH - 01-18-2015, 09:40 AM
RE: Edge Finder Disassembly - by Hawkeye - 01-18-2015, 07:44 PM
RE: Edge Finder Disassembly - by TomG - 01-18-2015, 08:15 PM
RE: Edge Finder Disassembly - by DaveH - 01-19-2015, 07:46 AM
RE: Edge Finder Disassembly - by Highpower - 01-19-2015, 09:49 AM
RE: Edge Finder Disassembly - by Mayhem - 01-19-2015, 08:32 AM
RE: Edge Finder Disassembly - by Bill Gruby - 01-19-2015, 10:15 AM
RE: Edge Finder Disassembly - by Bill Gruby - 01-19-2015, 08:51 AM
RE: Edge Finder Disassembly - by mcostello - 01-19-2015, 12:44 PM
RE: Edge Finder Disassembly - by Baron - 02-15-2015, 04:39 PM



Users browsing this thread: 1 Guest(s)