I need to make a small repair on my Franken Mill

Thread Modes

I need to make a small repair on my Franken Mill

mike-sid Offline

Sophmore

Posts: 137
Threads: 16
Joined: Jan 2015
Location: Oxford, CT

The following 1 user Likes mike-sid's post:
hermetic (01-18-2015)

01-18-2015, 11:26 AM

(01-18-2015, 11:03 AM)the penguin Wrote: Wouldn't be easier to just use a piece of hardened 3/8"-24, B-7 All-thread and pin the handle to it?

Would like me to send you a couple of pieces?

Thank you for the offer! But I want to make it myself. I need the practice. It is a very low tolerance part...even I can't mess it up as hard as I try

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

I need to make a small repair on my Franken Mill - by mike-sid - 01-17-2015, 02:22 PM

RE: I need to make a small repair on my Franken Mill - by PixMan - 01-17-2015, 08:34 PM

RE: I need to make a small repair on my Franken Mill - by mike-sid - 01-17-2015, 09:39 PM

RE: I need to make a small repair on my Franken Mill - by the penguin - 01-18-2015, 11:03 AM

RE: I need to make a small repair on my Franken Mill - by mike-sid - 01-18-2015, 11:26 AM

RE: I need to make a small repair on my Franken Mill - by Sunset Machine - 01-19-2015, 09:44 AM

RE: I need to make a small repair on my Franken Mill - by PixMan - 01-19-2015, 09:18 PM

RE: I need to make a small repair on my Franken Mill - by mike-sid - 01-19-2015, 09:58 PM

RE: I need to make a small repair on my Franken Mill - by mike-sid - 01-24-2015, 12:04 AM