Advice on carbide insert boring bar

Hello There, Guest! Register

Thread Modes

Advice on carbide insert boring bar

Mayhem Offline

Offline

purveyor of mischief

Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia

#12

01-16-2015, 09:54 PM

Looks like a good price on a very good brand.

Hunting American dentists since 2015.

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Advice on carbide insert boring bar - by mike-sid - 01-15-2015, 06:40 PM

RE: Advice on carbide insert boring bar - by EdK - 01-15-2015, 06:46 PM

RE: Advice on carbide insert boring bar - by mike-sid - 01-15-2015, 10:59 PM

RE: Advice on carbide insert boring bar - by EdK - 01-16-2015, 06:29 AM

RE: Advice on carbide insert boring bar - by Mayhem - 01-16-2015, 07:33 AM

RE: Advice on carbide insert boring bar - by PixMan - 01-16-2015, 08:30 AM

RE: Advice on carbide insert boring bar - by Highpower - 01-16-2015, 10:31 AM

RE: Advice on carbide insert boring bar - by EdK - 01-16-2015, 12:19 PM

RE: Advice on carbide insert boring bar - by mike-sid - 01-16-2015, 01:51 PM

RE: Advice on carbide insert boring bar - by PixMan - 01-17-2015, 10:37 PM

RE: Advice on carbide insert boring bar - by EdK - 01-16-2015, 06:00 PM

RE: Advice on carbide insert boring bar - by mike-sid - 01-16-2015, 09:51 PM

RE: Advice on carbide insert boring bar - by Mayhem - 01-16-2015, 09:54 PM

RE: Advice on carbide insert boring bar - by EdK - 01-16-2015, 09:54 PM

RE: Advice on carbide insert boring bar - by PixMan - 01-17-2015, 09:08 PM

RE: Advice on carbide insert boring bar - by mike-sid - 01-17-2015, 09:22 PM

RE: Advice on carbide insert boring bar - by mike-sid - 01-17-2015, 09:47 PM

RE: Advice on carbide insert boring bar - by Highpower - 01-18-2015, 10:08 AM

RE: Advice on carbide insert boring bar - by PixMan - 01-17-2015, 10:14 PM

RE: Advice on carbide insert boring bar - by DaveH - 01-18-2015, 10:19 AM

RE: Advice on carbide insert boring bar - by Highpower - 01-18-2015, 11:17 AM

RE: Advice on carbide insert boring bar - by PixMan - 01-18-2015, 12:08 PM

Users browsing this thread: 1 Guest(s)