01-15-2015, 07:40 AM
Willie,
I didn't use the CNC of my machine with the 1/32" end mill. The operation I used one on was that "sight leaf" that I'd made for dallen, milling the graduations. While the end mill was cutting full width is was only .0075" (about 0,2mm) deep.
I fed it by hand on the job.
I didn't use the CNC of my machine with the 1/32" end mill. The operation I used one on was that "sight leaf" that I'd made for dallen, milling the graduations. While the end mill was cutting full width is was only .0075" (about 0,2mm) deep.
I fed it by hand on the job.