01-14-2015, 06:53 PM
I worked in a shop that had a Hardinge Toolroom lathe and a Harig surface grinder and we used Vactra #2 in both of them. I'm sure they are still running just fine.
Tom
Tom
![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png)
|
Harig way oil
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Harig way oil - by Dr Stan - 01-14-2015, 08:53 AM
RE: Harig way oil - by arvidj - 01-14-2015, 10:12 AM
RE: Harig way oil - by TomG - 01-14-2015, 06:53 PM
RE: Harig way oil - by Dr Stan - 01-14-2015, 07:05 PM
RE: Harig way oil - by Mayhem - 01-15-2015, 08:42 AM
RE: Harig way oil - by Dr Stan - 01-15-2015, 12:08 PM
|
Users browsing this thread: 2 Guest(s)