01-12-2015, 07:48 PM
Pass given Jack! LOL
My recollection is that you have more end mills than Carter has little pills, so you need to toast a few of them to cut down on the overpopulation!
If they were carbide, you likely didn't do your job well enough and the end mills are still fine because your speed was low even for the 1/2" one.
Ken
My recollection is that you have more end mills than Carter has little pills, so you need to toast a few of them to cut down on the overpopulation!
If they were carbide, you likely didn't do your job well enough and the end mills are still fine because your speed was low even for the 1/2" one.
Ken