Fixing a Leaky RF-45 Mill Head - Enco

[EdK]

(05-14-2012, 06:04 AM)November X-ray Wrote:

(05-13-2012, 03:14 AM)Dave J Wrote: A tip for the Permatex getting on your fresh paint, is to run some electrical tape either side of the join while your putting it together, and then just remove it after woods. Using electrical tape is better than masking tape because it's not so sticky and wont peel your new paint off when removed.

Dave

If available to you, try the new "frog" masking tape, it won't stick hard enough to pull off your paint but it creates a barrier along the edge so nothing gets beneath it. It's available at most home improvement places.

November,

That is my plan since I already have some of the frog tape. It's worked well for me in the past so it should work to help keep the squeeze-out contained.

Ed