MetalworkingFun Forum › Machining › General Metalworking Discussion v
Pixman, When You Get A chance

Thread Modes
Pixman, When You Get A chance
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
The following 2 users Like Mayhem's post:
f350ca (01-07-2015), EdK (01-07-2015)
#15
01-07-2015, 07:26 AM
(01-06-2015, 07:43 PM)PixMan Wrote: ...I have some Valenite TPG321 grade 610 cermet inserts which leave a beautiful finish in crappy steels when carbide just won't...

I have cans of spray paint for that very same reason Big Grin
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Pixman, When You Get A chance - by the penguin - 01-03-2015, 01:35 PM
RE: Pixman, When You Get A chance - by PixMan - 01-03-2015, 02:42 PM
RE: Pixman, When You Get A chance - by PixMan - 01-04-2015, 01:26 PM
RE: Pixman, When You Get A chance - by PixMan - 01-04-2015, 02:47 PM
RE: Pixman, When You Get A chance - by PixMan - 01-06-2015, 08:21 AM
RE: Pixman, When You Get A chance - by Mayhem - 01-06-2015, 09:12 AM
RE: Pixman, When You Get A chance - by Mayhem - 01-06-2015, 10:31 AM
RE: Pixman, When You Get A chance - by PixMan - 01-06-2015, 07:43 PM
RE: Pixman, When You Get A chance - by Mayhem - 01-07-2015, 07:26 AM



Users browsing this thread: 1 Guest(s)