01-03-2015, 12:33 PM
Chuck,
The screw you should be using for an ISO standard 10mm RCxT10M0 insert would be an M3.5x7 (or longer), which would have a 60º head taking an T15 (Torx) or T15IP (Torx Plus) wrench/screwdriver.
There's a VERY good chance I've got something for you. I'll check and get back to within a couple of hours. I'm away from my shop but should be going over there later this afternoon.
Regards,
Ken
The screw you should be using for an ISO standard 10mm RCxT10M0 insert would be an M3.5x7 (or longer), which would have a 60º head taking an T15 (Torx) or T15IP (Torx Plus) wrench/screwdriver.
There's a VERY good chance I've got something for you. I'll check and get back to within a couple of hours. I'm away from my shop but should be going over there later this afternoon.
Regards,
Ken