[PROJECT] Clamp Knurling Tool

[EdK]

(01-01-2015, 01:28 PM)DaveH Wrote:

(01-01-2015, 01:22 PM)EdK Wrote: I've switched over to an end mill. I'll master the fly cutter some other time.

Ed

Good idea, sometimes one can get bogged down and not see the wood for the trees.
For your first go I thought it was pretty good - one has to grind the tool bit, bother about spindle speed and then slow feed by hand. All in all Ed it came out quite good

DaveH

Yup, I looked at it closer and it wasn't all the bad. Just not shiny metal camera good. I think it would have been better if I had power feed. Time to push that project higher up on the list. I also need to get a better grinder setup.

Ed