12-31-2014, 09:56 PM
(This post was last modified: 12-31-2014, 10:07 PM by the penguin.)
A friend of mine has a Grizzly G3103 mill, and wanted a table plate. He makes custom motorcycle parts and they are often oddly shaped, so he asked for the plate shown below. The plate is 34" x 9" x 1/2", and had (240) 3/8"-16 holes and (12) countersunk holes, he uses flathead allens and t-nuts to luck the plate to the mill table. It takes him about 10 minutes to get it in position.
jack