12-30-2014, 08:51 AM
(12-30-2014, 08:01 AM)stevec Wrote: Not doubting or challenging Darren but, I don't see no crack?
You were focusing on the wrong picture Steve!
(12-29-2014, 09:43 AM)Mayhem Wrote: ...A suitable replacement found in the inventory. Top left of this picture you can see the other side of the original retainer, with the boss that fits against the outer race of the bearing. You can also see the crack!...
The crack didn't actually go all the way through. I've highlighted the area below and if I remember, I will dig the part out of the scrap bin and take a picture of it. This is the problem I have at the moment, as my lathe and the scrap bin this part got tossed into is 25km (15 miles) from my house, which is where my mill is.
Hunting American dentists since 2015.