12-22-2014, 04:15 PM
(12-22-2014, 12:44 PM)EdK Wrote: Arvid,
Where is the Toll Gas located that you go to?
Thanks,
Ed
The only facility that actually does service is the one in Plymouth ... Plymouth Headquarters, 3005 Niagara Lane N., Plymouth, MN 55447.
The other locations will accept it but then send it on their next truck to Plymouth.
They said they were about two weeks behind, plus only open three days this week so I don't expect to get it back until late in January. The MIG has a DC scratch start TIG on it but I have never tried to attach the torch to the machine. Plus I'd have to plumb the argon tank to the MIG. Too much hassle.
I may say the heck with it and just use the MIG. I would have done that in the first place but this is a reasonably small piece and I think the MIG has .045 wire in it and I was not in the mood to change the wire spool, drive rollers, hose and gun to something appropriate for the work. But I have a few days off at the end of this week so I guess that's what I will do.
Arvid