12-22-2014, 07:19 AM
Nice work Greg! So it is an Acme thread after all then, eh? I thought you had said it was a square looking thread.
The 1mm thread should be easy as long as you don't have to go through the steps I do to change the gears. On my lathe I have to remove the collet closer's notched wheel to be able to open the end cover of the machine and get to the gears.
The 1mm thread should be easy as long as you don't have to go through the steps I do to change the gears. On my lathe I have to remove the collet closer's notched wheel to be able to open the end cover of the machine and get to the gears.