12-21-2014, 07:33 AM
So far I have had no luck on finding out the taper of the spindle. I'm hoping that there will be wheel hubs that I can pick up from other manufacturers that will fit. For example, this Chevalier looks virtually identical to a Boyar-Schultz 6x18 that I have seen.
I have made up a quick sketch based on the measurements I was able to get with my calipers. I'm hoping someone will recognise it.
618 Spindle Taper.JPG (Size: 24.32 KB / Downloads: 86)
I'm sure the large end is ø1.000 but I have based the drawing on what I got over several attempts...
Oh - Ken, you were correct. I can use 8" wheels (that much was in the manual).
I have made up a quick sketch based on the measurements I was able to get with my calipers. I'm hoping someone will recognise it.
618 Spindle Taper.JPG (Size: 24.32 KB / Downloads: 86)
I'm sure the large end is ø1.000 but I have based the drawing on what I got over several attempts...
Oh - Ken, you were correct. I can use 8" wheels (that much was in the manual).
Hunting American dentists since 2015.