MetalworkingFun Forum › Machining › Projects v
Stainless Steel Gas Spuds

Thread Modes
Stainless Steel Gas Spuds
the penguin Offline
Junior
****
Posts: 482
Threads: 89
Joined: Oct 2012
Location: camillus (syracuse), ny
The following 2 users Like the penguin's post:
PixMan (12-19-2014), EdK (12-20-2014)
#4
12-19-2014, 11:14 PM
10 - the 3/4" x 1/2" NPT bushing, cut down for clearance
11 - some of the finished spuds
12- ready to be boxed up, for shipment

After this set, I have more to make of different sizes and hole configuration


Attached Files Thumbnail(s)
           
jack
Reply
Thanks given by:


Messages In This Thread
Stainless Steel Gas Spuds - by the penguin - 12-19-2014, 11:05 PM
RE: Stainless Steel Gas Spuds - by the penguin - 12-19-2014, 11:08 PM
RE: Stainless Steel Gas Spuds - by the penguin - 12-19-2014, 11:11 PM
RE: Stainless Steel Gas Spuds - by the penguin - 12-19-2014, 11:14 PM
RE: Stainless Steel Gas Spuds - by PixMan - 12-19-2014, 11:54 PM
RE: Stainless Steel Gas Spuds - by the penguin - 01-08-2015, 04:06 PM
RE: Stainless Steel Gas Spuds - by the penguin - 12-20-2014, 01:30 AM
RE: Stainless Steel Gas Spuds - by Mayhem - 12-20-2014, 07:03 AM
RE: Stainless Steel Gas Spuds - by krv3000 - 12-20-2014, 07:26 PM
RE: Stainless Steel Gas Spuds - by Bill Gruby - 12-21-2014, 09:00 AM
RE: Stainless Steel Gas Spuds - by the penguin - 12-21-2014, 01:44 PM
RE: Stainless Steel Gas Spuds - by vtsteam - 12-21-2014, 06:26 PM
RE: Stainless Steel Gas Spuds - by PixMan - 12-21-2014, 07:47 PM
RE: Stainless Steel Gas Spuds - by vtsteam - 12-21-2014, 08:09 PM



Users browsing this thread: 2 Guest(s)