12-19-2014, 07:14 PM
That's pretty sweet looking, David!
What I would do with the end of the pins sticking out is either one of two things:
1) Measure the distance, push them out and shorten accordingly, press back in.
2) File down close, then stone to flush.
Even seeing it assembled I can't really figure out why the print called for that 120º feature on the cylinder that carries the 1/4-40 lateral (windage?) adjustment assembly. It would seem more appropriate to have something like that on the bottom tab to act as a stop for when you flip it up for use.
What I would do with the end of the pins sticking out is either one of two things:
1) Measure the distance, push them out and shorten accordingly, press back in.
2) File down close, then stone to flush.
Even seeing it assembled I can't really figure out why the print called for that 120º feature on the cylinder that carries the 1/4-40 lateral (windage?) adjustment assembly. It would seem more appropriate to have something like that on the bottom tab to act as a stop for when you flip it up for use.