|
VFD Question
|
12-16-2014, 11:05 PM
if I read you post right? you are asking if a 3hp VFD could run the 5hp motor with the 1hp load? if the starting load is low enough, the VFD only sees resistance / inductance , current draw, counter-EMF, so if it is in the parameters the VFD is designed for it should work. I have Lense, Toshiba, ???FM50 can't remember the name? on various machines, knock on wood they all work fine!
oldgoaly, proud to be a member of MetalworkingFun Forum since Jun 2013.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
VFD Question - by f350ca - 12-14-2014, 10:10 PM
RE: VFD Question - by stevec - 12-15-2014, 08:07 AM
RE: VFD Question - by 12345678910 - 12-16-2014, 08:32 PM
RE: VFD Question - by oldgoaly - 12-16-2014, 11:05 PM
RE: VFD Question - by dallen - 12-16-2014, 11:35 PM
RE: VFD Question - by f350ca - 12-17-2014, 12:38 AM
RE: VFD Question - by dallen - 12-17-2014, 01:36 AM
RE: VFD Question - by Terry S - 12-17-2014, 10:55 AM
RE: VFD Question - by Terry S - 12-17-2014, 11:10 AM
RE: VFD Question - by oldgoaly - 12-17-2014, 12:58 PM
RE: VFD Question - by f350ca - 12-17-2014, 02:26 PM
RE: VFD Question - by stevec - 12-18-2014, 09:34 AM
RE: VFD Question - by f350ca - 12-18-2014, 10:11 AM
RE: VFD Question - by f350ca - 01-16-2015, 09:32 PM
|
