MetalworkingFun Forum › Machining › General Metalworking Discussion v
Shaper rings

Thread Modes
Shaper rings
vtsteam Offline
Sophmore
***
Posts: 205
Threads: 3
Joined: Jul 2014
Location: Vermont
#11
12-13-2014, 01:27 PM
I've used hole saws on the mill. You can clamp the ring then. Stopping frequently and clearing chips is a pain, but I hadn't tried 350ca's clearance hole before -- that might make it easier. Lots of ways to skin a cat.
http://www.youtube.com/c/SRHacksaw
Reply
Thanks given by:


Messages In This Thread
Shaper rings - by schor - 12-12-2014, 02:41 PM
RE: Shaper rings - by PixMan - 12-12-2014, 02:50 PM
RE: Shaper rings - by f350ca - 12-12-2014, 07:34 PM
RE: Shaper rings - by PixMan - 12-12-2014, 10:23 PM
RE: Shaper rings - by f350ca - 12-12-2014, 11:34 PM
RE: Shaper rings - by stevec - 12-13-2014, 07:05 AM
RE: Shaper rings - by PixMan - 12-13-2014, 08:09 AM
RE: Shaper rings - by Sunset Machine - 12-13-2014, 10:02 AM
RE: Shaper rings - by DaveH - 12-13-2014, 11:11 AM
RE: Shaper rings - by Highpower - 12-13-2014, 11:44 AM
RE: Shaper rings - by vtsteam - 12-13-2014, 01:27 PM
RE: Shaper rings - by EdK - 12-13-2014, 01:31 PM
RE: Shaper rings - by DaveH - 12-28-2014, 01:05 PM
RE: Shaper rings - by schor - 12-28-2014, 01:38 PM
RE: Shaper rings - by DaveH - 12-28-2014, 02:03 PM



Users browsing this thread: 3 Guest(s)