Gluing Rubber To Bar
#7
if you can find the right size rubber hose, you should be able to plug one end and connect it to an air hose an force it over the roller before turning on the air just enough to swell the hose up so that it will slide down the roller, used to siip thick wall rubber tubing over 1" pipe using an air hose to inflate the rubber once it was started on the pipe.

DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:


Messages In This Thread
Gluing Rubber To Bar - by Sunset Machine - 09-21-2014, 09:34 AM
RE: Gluing Rubber To Bar - by hermetic - 12-12-2014, 05:27 PM
RE: Gluing Rubber To Bar - by arvidj - 12-12-2014, 08:34 PM
RE: Gluing Rubber To Bar - by Sunset Machine - 12-13-2014, 10:30 AM
RE: Gluing Rubber To Bar - by Highpower - 12-13-2014, 11:35 AM
RE: Gluing Rubber To Bar - by dallen - 12-13-2014, 10:41 AM
RE: Gluing Rubber To Bar - by dallen - 12-13-2014, 12:44 PM
RE: Gluing Rubber To Bar - by rleete - 12-13-2014, 09:37 PM
RE: Dumpster Dive Results - by TomG - 12-12-2014, 04:16 PM
RE: Dumpster Dive Results - by Bill Gruby - 12-12-2014, 04:27 PM



Users browsing this thread: 5 Guest(s)