MetalworkingFun Forum › Machining › General Metalworking Discussion v
Shaper rings

Thread Modes
Shaper rings
f350ca Offline
Senior
*****
Posts: 3,003
Threads: 51
Joined: Apr 2012
Location: Ontario
The following 1 user Likes f350ca's post:
Highpower (12-13-2014)
#5
12-12-2014, 11:34 PM
Use them all the time Ken, in aluminum that Ken's using I wouldn't even bother with coolant, just a shot of WD40. A hole drilled on the periphery of the circle to clear chips helps speed up the cut.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
Shaper rings - by schor - 12-12-2014, 02:41 PM
RE: Shaper rings - by PixMan - 12-12-2014, 02:50 PM
RE: Shaper rings - by f350ca - 12-12-2014, 07:34 PM
RE: Shaper rings - by PixMan - 12-12-2014, 10:23 PM
RE: Shaper rings - by f350ca - 12-12-2014, 11:34 PM
RE: Shaper rings - by stevec - 12-13-2014, 07:05 AM
RE: Shaper rings - by PixMan - 12-13-2014, 08:09 AM
RE: Shaper rings - by Sunset Machine - 12-13-2014, 10:02 AM
RE: Shaper rings - by DaveH - 12-13-2014, 11:11 AM
RE: Shaper rings - by Highpower - 12-13-2014, 11:44 AM
RE: Shaper rings - by vtsteam - 12-13-2014, 01:27 PM
RE: Shaper rings - by EdK - 12-13-2014, 01:31 PM
RE: Shaper rings - by DaveH - 12-28-2014, 01:05 PM
RE: Shaper rings - by schor - 12-28-2014, 01:38 PM
RE: Shaper rings - by DaveH - 12-28-2014, 02:03 PM



Users browsing this thread: 1 Guest(s)