MetalworkingFun Forum › Machining › General Metalworking Discussion v
What should I do with them?

Thread Modes
What should I do with them?
arvidj Offline
Junior
****
Posts: 736
Threads: 34
Joined: Feb 2012
Location: Minneapolis, MN
#10
12-12-2014, 08:41 PM
Thanks to everyone for their suggestions.

Ken, if I were to put them on Craig's List, what might be a far price? Obviously I would very much prefer holders that I can actually use.
Reply
Thanks given by:


Messages In This Thread
What should I do with them? - by arvidj - 12-12-2014, 04:11 PM
RE: What should I do with them? - by chucketn - 12-12-2014, 04:15 PM
RE: What should I do with them? - by Arbalest - 12-12-2014, 04:40 PM
RE: What should I do with them? - by EdK - 12-12-2014, 04:43 PM
RE: What should I do with them? - by doubleboost - 12-12-2014, 05:07 PM
RE: What should I do with them? - by doubleboost - 12-12-2014, 05:42 PM
RE: What should I do with them? - by chucketn - 12-12-2014, 06:27 PM
RE: What should I do with them? - by dallen - 12-12-2014, 07:37 PM
RE: What should I do with them? - by PixMan - 12-12-2014, 07:47 PM
RE: What should I do with them? - by arvidj - 12-12-2014, 08:41 PM
RE: What should I do with them? - by PixMan - 12-12-2014, 10:19 PM
RE: What should I do with them? - by Black Forest - 12-17-2014, 12:40 PM
RE: What should I do with them? - by dallen - 12-17-2014, 02:02 PM



Users browsing this thread: 3 Guest(s)