MetalworkingFun Forum › Machining › General Metalworking Discussion v
What should I do with them?

Thread Modes
What should I do with them?
dallen Offline
Senior
*****
Posts: 1,827
Threads: 51
Joined: Apr 2012
Location: Oklahoma
#8
12-12-2014, 07:37 PM
I've cut dovetails in them before, they come out pretty soft after a trip thru the furnace

DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:


Messages In This Thread
What should I do with them? - by arvidj - 12-12-2014, 04:11 PM
RE: What should I do with them? - by chucketn - 12-12-2014, 04:15 PM
RE: What should I do with them? - by Arbalest - 12-12-2014, 04:40 PM
RE: What should I do with them? - by EdK - 12-12-2014, 04:43 PM
RE: What should I do with them? - by doubleboost - 12-12-2014, 05:07 PM
RE: What should I do with them? - by doubleboost - 12-12-2014, 05:42 PM
RE: What should I do with them? - by chucketn - 12-12-2014, 06:27 PM
RE: What should I do with them? - by dallen - 12-12-2014, 07:37 PM
RE: What should I do with them? - by PixMan - 12-12-2014, 07:47 PM
RE: What should I do with them? - by arvidj - 12-12-2014, 08:41 PM
RE: What should I do with them? - by PixMan - 12-12-2014, 10:19 PM
RE: What should I do with them? - by Black Forest - 12-17-2014, 12:40 PM
RE: What should I do with them? - by dallen - 12-17-2014, 02:02 PM



Users browsing this thread: 2 Guest(s)