MetalworkingFun Forum › Machining › General Metalworking Discussion v
Gluing Rubber To Bar

Thread Modes
Gluing Rubber To Bar
Bill Gruby Offline
Sophmore
***
Posts: 218
Threads: 9
Joined: Dec 2014
Location: Bristol Ct. USA
#3
12-12-2014, 04:27 PM
The way I would do it if all I had was a glue method would be to cut the rubber into strips and wrap it around at an angle. It you wrap it with one straight seam I will guarantee it fails. Even the strip method may not hold but it is the better of the two methods.

"Billy G"
Reply
Thanks given by:


Messages In This Thread
Gluing Rubber To Bar - by Sunset Machine - 09-21-2014, 09:34 AM
RE: Gluing Rubber To Bar - by hermetic - 12-12-2014, 05:27 PM
RE: Gluing Rubber To Bar - by arvidj - 12-12-2014, 08:34 PM
RE: Gluing Rubber To Bar - by Sunset Machine - 12-13-2014, 10:30 AM
RE: Gluing Rubber To Bar - by Highpower - 12-13-2014, 11:35 AM
RE: Gluing Rubber To Bar - by dallen - 12-13-2014, 10:41 AM
RE: Gluing Rubber To Bar - by dallen - 12-13-2014, 12:44 PM
RE: Gluing Rubber To Bar - by rleete - 12-13-2014, 09:37 PM
RE: Dumpster Dive Results - by TomG - 12-12-2014, 04:16 PM
RE: Dumpster Dive Results - by Bill Gruby - 12-12-2014, 04:27 PM



Users browsing this thread: 6 Guest(s)