|
What should I do with them?
|
12-12-2014, 04:15 PM
Doubleboost just had a thread or video on modifying the holders to fit a tool post. On one, he milled a dovetail in the actual shank of the holder to fit his QCTP.
Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
What should I do with them? - by arvidj - 12-12-2014, 04:11 PM
RE: What should I do with them? - by chucketn - 12-12-2014, 04:15 PM
RE: What should I do with them? - by Arbalest - 12-12-2014, 04:40 PM
RE: What should I do with them? - by EdK - 12-12-2014, 04:43 PM
RE: What should I do with them? - by doubleboost - 12-12-2014, 05:07 PM
RE: What should I do with them? - by doubleboost - 12-12-2014, 05:42 PM
RE: What should I do with them? - by chucketn - 12-12-2014, 06:27 PM
RE: What should I do with them? - by dallen - 12-12-2014, 07:37 PM
RE: What should I do with them? - by PixMan - 12-12-2014, 07:47 PM
RE: What should I do with them? - by arvidj - 12-12-2014, 08:41 PM
RE: What should I do with them? - by PixMan - 12-12-2014, 10:19 PM
RE: What should I do with them? - by Black Forest - 12-17-2014, 12:40 PM
RE: What should I do with them? - by dallen - 12-17-2014, 02:02 PM
|
