|
Dimensioning Question
|
12-10-2014, 10:50 AM
(12-10-2014, 09:39 AM)rleete Wrote: BTW, I work at a place that does diamond machining for optical tooling. Those guys work to insane tolerances. Minutes of angle and tenths of an inch are pretty common around here. I have actually seen specifications that list tolerances in microns. That's 40 millionths of an inch. Mmm ........ 'and tenths of an inch' seems a bit big or am I missing something?  DaveH |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Dimensioning Question - by EdK - 12-09-2014, 12:49 PM
RE: Dimensioning Question - by dallen - 12-09-2014, 12:55 PM
RE: Dimensioning Question - by f350ca - 12-09-2014, 12:55 PM
RE: Dimensioning Question - by rleete - 12-09-2014, 12:59 PM
RE: Dimensioning Question - by EdK - 12-09-2014, 02:45 PM
RE: Dimensioning Question - by TomG - 12-09-2014, 06:58 PM
RE: Dimensioning Question - by rleete - 12-09-2014, 07:00 PM
RE: Dimensioning Question - by PixMan - 12-10-2014, 06:50 AM
RE: Dimensioning Question - by DaveH - 12-10-2014, 07:24 AM
RE: Dimensioning Question - by Mayhem - 12-10-2014, 08:16 AM
RE: Dimensioning Question - by TomG - 12-10-2014, 08:52 AM
RE: Dimensioning Question - by DaveH - 12-10-2014, 08:29 AM
RE: Dimensioning Question - by rleete - 12-10-2014, 09:39 AM
RE: Dimensioning Question - by DaveH - 12-10-2014, 10:50 AM
RE: Dimensioning Question - by JScott - 12-10-2014, 11:06 AM
RE: Dimensioning Question - by rleete - 12-10-2014, 05:08 PM
RE: Dimensioning Question - by TomG - 12-10-2014, 05:37 PM
RE: Dimensioning Question - by EdK - 12-10-2014, 05:38 PM
|
