MetalworkingFun Forum › Machining › General Metalworking Discussion v
Magnetic base restoration?

Thread Modes
Magnetic base restoration?
chucketn
Unregistered
 
#2
02-20-2012, 11:31 AM
Never been inside one of these magnetic bases. Would make a good investigative project. If it can't be repaired maybe it can be modified with a Neodymium magnet or a magnet salvaged from a bad compuer hard drive?
Go for it, I'm watching!
Reply
Thanks given by:


Messages In This Thread
Magnetic base restoration? - by Highpower - 02-20-2012, 11:19 AM
RE: Magnetic base restoration? - by chucketn - 02-20-2012, 11:31 AM
RE: Magnetic base restoration? - by DaveH - 02-20-2012, 01:05 PM
RE: Magnetic base restoration? - by PixMan - 02-20-2012, 05:34 PM
RE: Magnetic base restoration? - by Highpower - 02-20-2012, 10:23 PM
RE: Magnetic base restoration? - by chucketn - 02-21-2012, 06:19 AM
RE: Magnetic base restoration? - by Dave J - 02-21-2012, 11:10 AM
RE: Magnetic base restoration? - by Highpower - 02-23-2012, 10:32 AM
RE: Magnetic base restoration? - by DaveH - 02-23-2012, 04:19 PM
RE: Magnetic base restoration? - by Highpower - 02-23-2012, 10:06 PM
RE: Magnetic base restoration? - by krv3000 - 02-25-2012, 04:49 PM
RE: Magnetic base restoration? - by krv3000 - 02-26-2012, 06:30 PM
RE: Magnetic base restoration? - by DaveH - 02-26-2012, 06:44 PM



Users browsing this thread: 1 Guest(s)