MetalworkingFun Forum › Machining › General Metalworking Discussion v
Dimensioning Question

Thread Modes
Dimensioning Question
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
#6
12-09-2014, 06:58 PM
Dowel pins are always 2-3 tenths oversize so they fit snugly in a nominally sized hole. In reality though, you would ream the hole undersize for a good press fit, or oversize for a slip fit.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
Dimensioning Question - by EdK - 12-09-2014, 12:49 PM
RE: Dimensioning Question - by dallen - 12-09-2014, 12:55 PM
RE: Dimensioning Question - by f350ca - 12-09-2014, 12:55 PM
RE: Dimensioning Question - by rleete - 12-09-2014, 12:59 PM
RE: Dimensioning Question - by EdK - 12-09-2014, 02:45 PM
RE: Dimensioning Question - by TomG - 12-09-2014, 06:58 PM
RE: Dimensioning Question - by rleete - 12-09-2014, 07:00 PM
RE: Dimensioning Question - by PixMan - 12-10-2014, 06:50 AM
RE: Dimensioning Question - by DaveH - 12-10-2014, 07:24 AM
RE: Dimensioning Question - by Mayhem - 12-10-2014, 08:16 AM
RE: Dimensioning Question - by TomG - 12-10-2014, 08:52 AM
RE: Dimensioning Question - by DaveH - 12-10-2014, 08:29 AM
RE: Dimensioning Question - by rleete - 12-10-2014, 09:39 AM
RE: Dimensioning Question - by DaveH - 12-10-2014, 10:50 AM
RE: Dimensioning Question - by JScott - 12-10-2014, 11:06 AM
RE: Dimensioning Question - by rleete - 12-10-2014, 05:08 PM
RE: Dimensioning Question - by TomG - 12-10-2014, 05:37 PM
RE: Dimensioning Question - by EdK - 12-10-2014, 05:38 PM



Users browsing this thread: 2 Guest(s)