Dimensioning Question

Thread Modes

Dimensioning Question

EdK

Whipping Boy

Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota

12-09-2014, 02:45 PM

(12-09-2014, 12:59 PM)rleete Wrote: It's the tolerance. It can be larger (the +) by up to .0003, but might be only as large as .0001 more. So, the dowel will come to you at .2501 (smallest) to .2503 (largest) or anywhere in between.

This dowel is meant to be tightly fitting (I would classify this as a press fit) in an accurately drilled 1/4" hole.

OK, that kind of makes some sense.

Ed

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

Dimensioning Question - by EdK - 12-09-2014, 12:49 PM

RE: Dimensioning Question - by dallen - 12-09-2014, 12:55 PM

RE: Dimensioning Question - by f350ca - 12-09-2014, 12:55 PM

RE: Dimensioning Question - by rleete - 12-09-2014, 12:59 PM

RE: Dimensioning Question - by EdK - 12-09-2014, 02:45 PM

RE: Dimensioning Question - by TomG - 12-09-2014, 06:58 PM

RE: Dimensioning Question - by rleete - 12-09-2014, 07:00 PM

RE: Dimensioning Question - by PixMan - 12-10-2014, 06:50 AM