MetalworkingFun Forum › Machining › General Metalworking Discussion v
Dimensioning Question

Thread Modes
Dimensioning Question
dallen Offline
Senior
*****
Posts: 1,827
Threads: 51
Joined: Apr 2012
Location: Oklahoma
#2
12-09-2014, 12:55 PM
I'd take it to mean that the pins can be from .0001 to .0003 bigger then .250
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:


Messages In This Thread
Dimensioning Question - by EdK - 12-09-2014, 12:49 PM
RE: Dimensioning Question - by dallen - 12-09-2014, 12:55 PM
RE: Dimensioning Question - by f350ca - 12-09-2014, 12:55 PM
RE: Dimensioning Question - by rleete - 12-09-2014, 12:59 PM
RE: Dimensioning Question - by EdK - 12-09-2014, 02:45 PM
RE: Dimensioning Question - by TomG - 12-09-2014, 06:58 PM
RE: Dimensioning Question - by rleete - 12-09-2014, 07:00 PM
RE: Dimensioning Question - by PixMan - 12-10-2014, 06:50 AM
RE: Dimensioning Question - by DaveH - 12-10-2014, 07:24 AM
RE: Dimensioning Question - by Mayhem - 12-10-2014, 08:16 AM
RE: Dimensioning Question - by TomG - 12-10-2014, 08:52 AM
RE: Dimensioning Question - by DaveH - 12-10-2014, 08:29 AM
RE: Dimensioning Question - by rleete - 12-10-2014, 09:39 AM
RE: Dimensioning Question - by DaveH - 12-10-2014, 10:50 AM
RE: Dimensioning Question - by JScott - 12-10-2014, 11:06 AM
RE: Dimensioning Question - by rleete - 12-10-2014, 05:08 PM
RE: Dimensioning Question - by TomG - 12-10-2014, 05:37 PM
RE: Dimensioning Question - by EdK - 12-10-2014, 05:38 PM



Users browsing this thread: 4 Guest(s)