Dave,
I suspected that you mean the divider. Wouldn't the hole from the centre drill too rounded to accurately hold the pointy end of the divider? I've this:
![[Image: e780d4f5.jpg]](http://i1207.photobucket.com/albums/bb469/wongstersproduction/e780d4f5.jpg)
Picked it up used. Will using the divider gives the required accuracy to match up with the exacting taped holes on the spindle flange?
Regards,
Wong
I suspected that you mean the divider. Wouldn't the hole from the centre drill too rounded to accurately hold the pointy end of the divider? I've this:
Picked it up used. Will using the divider gives the required accuracy to match up with the exacting taped holes on the spindle flange?
Regards,
Wong
Wongster
http://www.wongstersproduction.com
Proud to be a member of MetalworkingFun Forum since Mar 2012.
http://www.wongstersproduction.com
Proud to be a member of MetalworkingFun Forum since Mar 2012.