ER32 Collet Chuck for Proxxon PD 400

[DaveH]

(05-13-2012, 08:00 AM)Wongster Wrote: Dave,

How do I centre the tool/scriber in the tool post do that I can move the cross slide to scribe the circle for the mounting holes? To index for the 3 hole positions, will the 3 jaws if the chuck be sufficient to act as positional stops? I don't have any means to index the spindle.

Regards,
Wong

Hi Wong,
May be I am using the wrong words -pair of scriber's. Their real name is dividers, much like a pair of compass - only both ends have a point

Sorry Wong may have confused you a little here, so there is no need to index on the lathe or to put a scriber in the tool post.

Use the divider's as you would a pair of compass


DaveH