05-13-2012, 08:00 AM
Dave,
How do I centre the tool/scriber in the tool post do that I can move the cross slide to scribe the circle for the mounting holes? To index for the 3 hole positions, will the 3 jaws if the chuck be sufficient to act as positional stops? I don't have any means to index the spindle.
Regards,
Wong
How do I centre the tool/scriber in the tool post do that I can move the cross slide to scribe the circle for the mounting holes? To index for the 3 hole positions, will the 3 jaws if the chuck be sufficient to act as positional stops? I don't have any means to index the spindle.
Regards,
Wong
Wongster
http://www.wongstersproduction.com
Proud to be a member of MetalworkingFun Forum since Mar 2012.
http://www.wongstersproduction.com
Proud to be a member of MetalworkingFun Forum since Mar 2012.