MetalworkingFun Forum › Machining › General Metalworking Discussion v
Plans for T tap wrench ?

Thread Modes
Plans for T tap wrench ?
Arbalest Offline
Sophmore
***
Posts: 175
Threads: 4
Joined: Sep 2012
Location: Dorset, UK
#9
11-30-2014, 02:16 PM
I'm surprised they are so expensive. I have four of the Eclipse (UK) equivalent  and they often turn up at the shows new or used for a couple of pounds each.

[Image: ECL141TWR-500x500.jpg]
Arbalest, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by:


Messages In This Thread
Plans for T tap wrench ? - by 12345678910 - 11-29-2014, 04:29 PM
RE: Plans for T tap wrench ? - by chucketn - 11-29-2014, 05:49 PM
RE: Plans for T tap wrench ? - by EdK - 11-29-2014, 06:11 PM
RE: Plans for T tap wrench ? - by 12345678910 - 11-29-2014, 08:00 PM
RE: Plans for T tap wrench ? - by chucketn - 11-29-2014, 09:47 PM
RE: Plans for T tap wrench ? - by Mayhem - 11-29-2014, 11:15 PM
RE: Plans for T tap wrench ? - by PixMan - 11-30-2014, 12:15 AM
RE: Plans for T tap wrench ? - by 12345678910 - 11-30-2014, 12:44 AM
RE: Plans for T tap wrench ? - by Arbalest - 11-30-2014, 02:16 PM
RE: Plans for T tap wrench ? - by 12345678910 - 11-30-2014, 06:51 PM
RE: Plans for T tap wrench ? - by stevec - 11-30-2014, 03:39 PM
RE: Plans for T tap wrench ? - by Arbalest - 12-01-2014, 05:59 AM
RE: Plans for T tap wrench ? - by Arbalest - 12-01-2014, 06:01 AM
RE: Plans for T tap wrench ? - by EdK - 12-01-2014, 08:50 AM



Users browsing this thread: 2 Guest(s)