Plans for T tap wrench ?
#2
Here's one that fits your requirements. Scaleable up or down.

Chuck


Attached Files
.pdf   Tap Wrench.pdf (Size: 136.98 KB / Downloads: 52)
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:


Messages In This Thread
Plans for T tap wrench ? - by 12345678910 - 11-29-2014, 04:29 PM
RE: Plans for T tap wrench ? - by chucketn - 11-29-2014, 05:49 PM
RE: Plans for T tap wrench ? - by EdK - 11-29-2014, 06:11 PM
RE: Plans for T tap wrench ? - by 12345678910 - 11-29-2014, 08:00 PM
RE: Plans for T tap wrench ? - by chucketn - 11-29-2014, 09:47 PM
RE: Plans for T tap wrench ? - by Mayhem - 11-29-2014, 11:15 PM
RE: Plans for T tap wrench ? - by PixMan - 11-30-2014, 12:15 AM
RE: Plans for T tap wrench ? - by 12345678910 - 11-30-2014, 12:44 AM
RE: Plans for T tap wrench ? - by Arbalest - 11-30-2014, 02:16 PM
RE: Plans for T tap wrench ? - by 12345678910 - 11-30-2014, 06:51 PM
RE: Plans for T tap wrench ? - by stevec - 11-30-2014, 03:39 PM
RE: Plans for T tap wrench ? - by Arbalest - 12-01-2014, 05:59 AM
RE: Plans for T tap wrench ? - by Arbalest - 12-01-2014, 06:01 AM
RE: Plans for T tap wrench ? - by EdK - 12-01-2014, 08:50 AM



Users browsing this thread: 5 Guest(s)