11-29-2014, 04:29 PM
Plans for T tap wrench ?
I'd like to make some good tap wrenches
I'm using Starrett 93C 1/4 to 1/2." range as an example
Unless I spring for Starret brand new tols, the local stores here just have those hardware store quality ones at 3/4 of the starrett price
The Starrett are nice, but I can't find used ones and depending on the source come out to $70 ish with tax and so on
If it goes well, I'd do a few for relatives and friends.
They have this on the website
http://www.starrett.com/metrology/product-detail/93C
http://www.starrett.com/dms/download.asp...&p=93C&i=3
I was hopint that this is a popular apprentice project and these are published in project books or magazine articles.
I'd like to make some good tap wrenches
I'm using Starrett 93C 1/4 to 1/2." range as an example
Unless I spring for Starret brand new tols, the local stores here just have those hardware store quality ones at 3/4 of the starrett price
The Starrett are nice, but I can't find used ones and depending on the source come out to $70 ish with tax and so on
If it goes well, I'd do a few for relatives and friends.
They have this on the website
http://www.starrett.com/metrology/product-detail/93C
http://www.starrett.com/dms/download.asp...&p=93C&i=3
I was hopint that this is a popular apprentice project and these are published in project books or magazine articles.